SONY ZS-D50
Instrukcja Obsługi

Tip If you made a mistake, press CANCEL. The setting entered last will be cleared. Re-enter it.

5

Set the timer to the hour and the minutes you want to start recording. 1 Press TUNING TIME SET + or � to set the hour and press ENTER�MEMORY CHECK. 2 Press TUNING TIME SET + or � to set the minutes, and press ENTER�MEMORY CHECK.

6 7
Tips � To exit the standby mode, press STANDBY twice to make the t indication disappear. � The preset settings remain until you reset them. � When you select both sides recording, the recording will stop after the both sides recording finishes so that accidental recording will not be made. � The display window does not light while the recording timer is on.

Set the timer to the hour and the minutes you want to stop recording. (Do as step 5.) Press TUNING TIME SET + or � to set the volume you want, and press ENTER�MEMORY CHECK. Press STANDBY. The power goes off and the player enters the standby mode. The t indication and the recording side of the tape (upper side ( or reverse side 9) appear in the display. If the 9 indication appears, press STANDBY to change the recording side to ( . At the preset time, the power will go on and the recording will start. Then the power will go off at the preset time, and the player will enter the standby mode again.

8

The Timer

To check/change the recording timer settings Press TIMER, then ENTER�MEMORY CHECK. Each time you press ENTER�MEMORY CHECK, a stored setting is displayed in the set order. To change the setting, display the setting you want to change and re-enter it. To use the player before a timer-recording starts If you turn on the player, you can use it as usual. Before the preset time, tune in the station you want to record and turn off the power. To stop timer-recording Turn off the power.
The Timer

33