jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
Tekstowy podgląd strony 6 (kliknij aby zobaczyć)
SECTION 3 MECHANICAL ADJUSTMENTS
Precaution 1. Clean the following parts with a denatured-alcoholmoistened swab: playback head pinch roller capstan rubber belt 2. Demagnetize the playback head with a head demagnetizer. 3. Do not use a magnetized screwdriver for the adjustments. 4. After the adjustments, apply suitable locking compound to the parts adjusted. 5. The adjustments should be performed with the rated power supply voltage (2.5 V) unless otherwise noted. Torque Measurement
Mode FWD FWD Back Tension FF, REW CQ-201B Torque Meter CQ-102C Meter Reading 20 � 42 g�cm (0.28 � 0.58 oz�inch) less than 2 g�cm (less than 0.03 oz�inch) more than 60 g�cm (more than 0.83 oz�inch)
SECTION 4 ELECTRICAL ADJUSTMENTS
Precaution � Supplied voltage: 2.5 V � Switch and control position TAPE switch: NORM RADIO switch: DX VOLUME CONTROL: maximum AVLS switch: NORM MEGA BASS switch: OFF Test tape
Type WS-48A Signal 3 kHz, 0 dB Used for Tape Speed Adjustment
TAPE SECTION
0 dB=0.775 V
Tape Speed Adjustment Procedure:
test tape WS-48A (3 kHz, 0dB) 16 � set
+ �
frequency counter
2 jack (J301)
Playback WS-48A (tape center part) and adjust RV601 so that the frequency counter reading becomes 3,000 Hz. Standard value: 2,985 to 3,015 Hz Adjustment Location:
