jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
Tekstowy podgląd strony 38 (kliknij aby zobaczyć)
RCD-W2000ES
4.
CDM65-RBD2 Electrical Adjustment
4-1. Laser Power Adjustment 1) 2) Start up the TeraTermPro and set the switch S510 on the jig to �CONTROL�. Select the menu as follows. Control � Macro, and select 01ldp_S.ttl. Press �Open�. (Fig. 4-1)
4 Fig. 4-1
3) 4) 5)
Press the �RESET� button (SW101) of the jig as prompted by the display. Press the �RESET� button (SW101) of the jig again as prompted by the display. When the display as shown in Fig. 4-2 appears, type the serial number (see Fig. 4-3) that is printed on the label attached to the RBD2. (This dialog appears only when the EEPROM IC502 is replaced.)
4 Fig. 4-2
4 Fig. 4-3
When the display as shown in Fig. 4-4 appears, press �No�.
4 Fig. 4-4
When the display as shown in Fig. 4-5 appears after that, press �Yes�.