|
Kto jest w sklepie?
Sklep przegląda 5739 gości
|
Kategorie
|
Informacje
|
Polecamy
|
|
|
|
|
Dla tego produktu nie napisano jeszcze recenzji!
;
Schematy są ale można wysilić się i zrobić kolorowy skan i o większej rozdzielczości. Wtedy schematy płytek będą czytelniejsze. Całość super jako wartość merytoryczna. Wszystkie dane potrzebne do podłączenia różnego rodzajów urządzeń takich gramofon, CD itd.
;
Szybko, sprawnie i tanio. Serwis godny polecenia. Będę polecał innym
;
Ogólnie jest OK, z wyjątkiem obrazu płyty głównej, który jest miejscami mało czytelny, ale można sobie poradzić.
;
Dokładna dokumentacja, pomogła w szybkiej naprawie telewizora. Dziękuję!
;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
2-7. PICTURE TUBE REMOVAL Note:
� Please make sure the TV set is not in standing position before removing necessary CRT support located on bottom right and left.
� REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon paint on the CRT.
� REMOVING PROCEDURES
!¢ Cushion
a
!£ Demagnetic coil
!� Holder DGC
a
!� Chassis assy 4 Two screws (washer head) (+P 4 � 16)
1 Turn up one side of the rubber cap in the direction indicated by the arrow a.
b b
!¡ CV board 9 Tension spring 7 Two screws (Tapping 7+ Crown Washer) PWB Bracket
!º Deflection yoke 5 Speaker (15 � 6.5cm) 6 Two screws (Tapping 7+ Crown Washer)
2 Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b.
c
� 11 �
Coating earth assy 8 Anode cap
CRT Support Block
Screw Location 2 screws (+BVTP 4 � 16) 2 Two screws (washer head) (+P 4 � 16)
Anode Button
Beznet Hook
3 When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c. 1 Do not damage the surface of anode-caps with sharp shaped objects. 2 Do not press the rubber too hard so as not to damage the inside of anode-cap. A metal fitting called the shatter-hook terminal is built into the rubber. 3 Do not turn the foot of rubber over too hard. The shatter-hook terminal will stick out or damage the rubber.
�
HOW TO HANDLE AN ANODE-CAP
!§ Picture tube 1 Cushion
3 Speaker (15 � 6.5cm)
CRT Support Block
KV-HA21P50
RM-969
|
|
|
> |
|