jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
Tekstowy podgląd strony 22 (kliknij aby zobaczyć)
KV-28WF1
2-7. PICTURE TUBE REMOVAL
�
REMOVAL OF ANODE-CAP
carbon paint on the CRT, after removing the anode.
Note: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or 6 Two DGC holers 7 Degaussing coil 8 Spring extension
* REMOVING PROCEDURES. c
a
b b
Anode button
1 Turn up one side of the rubber cap in the direction indicated by the arrow a
3 C board 4 Neck assy 2 Chassis assy
2 Using a thumb pull up the rubber cap 3 When one side of the rubber cap is firmly in the direction indicated by the separated from the anode button, the arrow b anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c
�
1
2 3
9 Four PT screws 5 Deflection yoke
HOW TO HANDLE AN ANODE-CAP Don't damage the surface of anode-cap with sharp shaped material ! Don't press the rubber hardly not to hurt inside of anode-caps ! A metal fitting called as shatter-hook terminal is built into the rubber. Don�t turn the foot of rubber over hardly ! The shatter-hook terminal will stick out or damage the rubber.
